Publicité
Les langues disponibles
Les langues disponibles
IF THE OVEN IS PROVIDED BY THE MANUFACTURER WITHOUT PLUG:
• THE APPLIANCE MUST NOT BE CONNECTED TO THE POWER
SOURCE USING PLUG OR SOCKETS, BUT MUST BE DIRECTLY
CONNECTED TO THE SUPPLY MAINS. The connection to the power
source must be carried out by a suitably qualified professional. In
order to have an installation compliant to the current safety
legislation the oven must be connected only placing an omnipolar
breaker, with contact separation compliant to the requirements for
overvoltage category III, between the appliance and the power
source. The omnipolar breaker must bear the maximum connected
load and must be in line with current legislation. The yellow-green
earth cable should not be interrupted by the breaker. The omnipolar
breaker used for the connection must be easily accessible when the
appliance is installed.
• The connection to the power source must be carried out by a
suitably qualified professional considering the polarity of the oven
and of the power source.
• The disconnection must be achieved incorporating a switch in the
fixed wiring in accordance with the wiring rules
IF THE OVEN IS PROVIDED BY THE MANUFACTURER WITH PLUG:
• The socket must be suitable for the load indicated on the tag and
must have ground contact connected and in operation. The earth
conductor is yellow-green in colour. This operation should be carried
out by a suitably qualified professional. ln case of incompatibility
between the socket and the appliance plug, ask a qualified electrician
to substitute the socket with another suitable type. The plug and the
socket must be conformed to the current norms of the installation
country. Connection to the power source can also be made by placing
an omnipolar breaker, with contact separation compliant to the
requirements for overvoltage category III, between the appliance
and the power source that can bear the maximum connected load
and that is in line with current legislation. The yellow-green earth
cable should not be interrupted by the breaker. The socket or
omnipolar breaker used for the connection should be easily
EN 03
Publicité
