Publicité
Les langues disponibles
Les langues disponibles
ENG
Display of normal running
On the occurrence of a failure, the corresponding icons will give a combined blink:
the error codes and types are shown as follows:
Refrigerator
Error Code
E1
E2
E6
E7
If no failure, the screen displays the setting temperature of the refrigerator room.
Standby function
Long press the standby button
Temperature setting
The temperature setting will be changed once you pres button
according to the new temperature setting after 15s.
MAINTENANCE AND CARE OF THE
APPLIANCE
Overall cleaning
• Dusts behind the refrigerator and on the ground shall be timely cleaned to improve the cooling effect
and energy saving.
• Check the door gasket regularly to make sure there are no debris. Clean the door gasket with a soft
cloth dampened with soapy water or diluted detergent.
• The interior of the refrigerator should be cleaned regularly to avoid odor.
• Please turn off the power before cleaning interior, remove all foods, drinks .shelves, drawers, etc.
• Use a soft cloth or sponge to clean the inside of the refrigerator, with two tablespoons of baking soda
and a quart of warm water. Then rinse with water and wipe clean. After cleaning, open the door and let
it dry naturally before turning on the power.
• For areas that are difficult to clean in the refrigerator (such as narrow sandwiches, gaps or corners), it is
recommended to wipe them regularly with a soft rag, soft brush, etc. and when necessary, combined
with some auxiliary tools (such as thin sticks) to ensure no contaminants or bacterials accumulation in
these areas.
• Do not use soap, detergent, scrub powder, spray cleaner, etc., as these may cause odors in the interior
of the refrigerator or contaminated food.
• Clean the bottle frame, shelves and drawers with a soft cloth dampened with soapy water or diluted
detergent. Dry with a soft cloth or dry naturally.
Error Description
Temperature sensor of Refrigerator room fail
Defrosting sensor of Refrigerator room fail
Communication error
Ambient temperature sensor error
for the 10 seconds to set the standby function.
10
Display
Icon "
" & Icon "2" shine at
same time
Icon "
" & Icon "3" shine at
same time
Icon "2" & Icon "4" shine at
same time
Icon "
" & Icon "4" shine at
same time
. Then, the refrigerator will run
Publicité
