Phonak FreeCom 7100 Mode D'emploi page 8

D Connectors
D1 To connect FreeCom 7100
u The Phonak FreeCom 7100 headset can be combined with a variety of Phonak FreeCom
adapters for connecting to different aircraft audio panels (Fig 17).
u To connect the FreeCom 7100 to the aircraft audio panel, use the suitable adapter:
U Twin plugs PJ055/PJ068
U XLR-5
U U174/U
FreeCom
14
e-Box PJ055/PJ068
e-Box XLR-5
e-Box U174/U
Fig 17
D Connectors
The QD-connector is used to connect the Phonak FreeCom headset to the FreeCom Adapter.
It can be easily connected and disconnected, allowing a pilot to leave his/her seat without
needing to remove the headset or disconnect the FreeCom adapter from the aircraft's main
panel (e.g. for getting out of the plane while keeping a hearing protection).
u To open: pull apart the connector housing (never pull on the cables!)
u To close: the white markings on both connector housings must be aligned and then pushed
together (Fig 18).
u Do not turn on the cable screw jonts.
u Do not fold the cable (Fig 19).
u Never pull any connector by the cable! This may damage the cable and the connector and
cause communication problems.
Fig 18
Fig 19
15