Publicité
Les langues disponibles
Les langues disponibles
I N S TA L L AT I O N G U I D E L I N E S
TRUSS MOUNT INSTALLATION
Insert 18.8 steel M10x20mm or M12x25mm bolt (not included) through the respective mounting hole
of the clamp (not included), and then thread it into the matching 10M hole (shown below left), or 12M
hole (shown below right). The bolt must be threaded at least 18mm (0.7ins) into the fixture base.
FALLING FIXTURES CAN CAUSE SEVERE INJURY OR SERIOUS EQUIPMENT
DAMAGE! FOR THIS REASON, FIXTURES SHOULD BE INSTALLED AND INSPECTED
ONLY BY QUALIFIED PERSONNEL. DO NOT INSTALL THE UNIT IF YOU LACK THE
QUALIFICATIONS TO DO SO, OR IF YOU HAVE DOUBTS ABOUT THE SAFETY AND
SECURITY OF THE INSTALLATION SETUP OR LOCATION!
ALWAYS ATTACH A SAFETY CABLE WHENEVER INSTALLING THIS FIXTURE IN A
SUSPENDED ENVIRONMENT TO ENSURE THE FIXTURE WILL NOT FALL IF THE
CLAMP FAILS.
15
Publicité
