Onvis SMS2 Manuel D'utilisation page 2

QUICK START GUIDE
EN
1. Insert the included 2 AAA alkaline batteries and close the cover.
2. Make sure the Bluetooth of your iOS device is on.
3. Use the Home app, or download the free Onvis Home App and open it.
4. Tap the 'Add accessory' button, and scan the QR code on the SMS2 to add the accessory to your
Apple Home system.
5. Name the SMS2 smart motion sensor. Assign it to a room.
6. Set up an Apple Home hub (HomePod Mini and Apple TV4K2021 or later with Thread) to enable
Thread+Bluetooth connection, remote control, notification and automation.
7. For troubleshooting visit:
Note:
When QR code scanning is NOT applicable, you may manually input the SETUP code printed on
•
the QR code label.
If the app prompts "Couldn't add Onvis-XXXXXX", please reset and re-add the device. Please keep
•
the QR code for future use.
The use of a HomeKit-enable accessory needs the follow permissions:
•
a. Settings>iCloud>iCloud Drive>Turn On
b. Settings>iCloud>Keychain>Turn On
c. Settings>Privacy>HomeKit>Onvis Home>Turn On
Thread and Apple Home Hub Setting
Controlling this HomeKit-enabled accessory automatically and away from home requires a HomePod,
HomePod mini, or Apple TV set up as a home hub. It is recommended that you update to the
latest software and operating system.
To build an Apple Thread network, Apple HomePod mini or TV 4K 2021 is required.
You may find the instruction here:
http://www.onvistech.com/Support/9.html
https://support.apple.com/en-us/HT207057