Uline H-7606 Mode D'emploi page 2

LEGS AND FRAME ASSEMBLY
NOTE: Tabletops add 1⁄ – 1⁄" depending on
top purchased.
1. Flip legs upside down. Place adjustable feet into legs
and slide to desired height. Fasten adjustable feet to
legs with two M10 x 65 hex bolts and two M10 nuts per
adjustable foot using a 17 mm wrench. (See Figure 1)
Figure 1
M10 x 65
Hex Bolt
Leg
2. Turn legs upright and spread apart to accommodate
full depth bottom shelf. Place full depth bottom shelf
across leg braces. (See Figure 2)
Figure 2
Leg
Brace
Full Depth
Bottom Shelf
PAGE 2 OF 9
Adjustable
Feet
M10 Nut
Leg
Leg
Brace
ASSEMBLY
3. While bottom shelf is sitting on leg braces, slide two
bottom shelf support bars underneath shelf and line
them up with outer holes in leg brace and shelf. Fasten
support bars to shelf and leg brace with four M8 x 40
hex bolts per support bar using a 13 mm wrench.
Fasten center of leg brace and shelf together with four
M8 x 40 hex bolts and M8 nuts using a 13 mm wrench.
(See Figure 3)
Figure 3
Leg
Brace
M8 x 40
Hex Bolt
4. Position frame support bars so that the larger holes
are facing down. Line up with legs. Fasten support
bars to legs with four M8 x 65 hex bolts per leg using
a 13 mm wrench. (See Figure 4)
Figure 4
Bottom Shelf
Support Bars
M8 x 40
Hex Bolts
Frame Support
Bars
M8 x 65
Hex Bolts
1020 IH-7606