Télécharger Imprimer la page

Hilti TE 60-A36 Notice D'utilisation Originale page 8

Masquer les pouces Voir aussi pour TE 60-A36:

Publicité

Les langues disponibles

Les langues disponibles

1.3
Product-dependent symbols
1.3.1
Symbols on the product
The following symbols are used on the product:
Drilling with hammering action (hammer drilling)
Chiseling
Chisel positioning
Protection class II (double-insulated)
Revolutions per minute
Rated speed under no load
Diameter
1.4
Switching on and off
Symbols
Product is switched on
Product is switched off
1.5
Product information
Hilti products are designed for professional use and may be operated, serviced and maintained only by
trained, authorized personnel. This personnel must be informed of any particular hazards that may be
encountered. The product and its ancillary equipment can present hazards if used incorrectly by untrained
personnel or if used not in accordance with the intended use.
The type designation and serial number are stated on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information
Combihammer
Generation
Serial no.
1.6
Declaration of conformity
We declare, on our sole responsibility, that the product described here complies with the applicable directives
and standards. A copy of the declaration issued by the certification department can be found at the end of
this documentation.
The technical documentation is filed and stored here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistrasse 6 | 86916 Kaufering, Germany
2
Safety
2.1
General power tool safety warnings
WARNING Read all safety warnings, instructions, illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Work area safety
▶ Keep work area clean and well lit. Cluttered or dark areas invite accidents.
2
English
Printed: 06.06.2018 | Doc-Nr: PUB / 5434400 / 000 / 00
TE 60­A36
04
2201899
*2201899*

Publicité

loading