Hilti TE 60-A36 Notice D'utilisation Originale page 13

3.8 Items supplied
Combihammer, side handle, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or online at:
www.hilti.group | USA: www.hilti.com
4 Technical data
Rated voltage
Weight
Single impact energy
Hammer drill bits, Ø
Breach bits, Ø
Percussion core bits, Ø
PCM diamond core bits, Ø
Drill bits for metal, Ø
Drill bits for wood, Ø
Chuck
5 Operation
5.1 Preparations at the workplace
Switch the product off or remove the battery before making adjustments or changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1.1 Removing the battery
1. Press the release buttons on the battery.
2. Pull the battery out toward the rear.
5.1.2 Fitting the side handle
CAUTION
Risk of injury! Loss of control over the combihammer.
▶ Check that the side handle is fitted correctly and tightened securely. Check that the clamping band is
engaged in the groove provided on the tool.
CAUTION
Risk of injury. The depth gauge, if fitted but not used, might hinder the operator.
▶ Remove the depth gauge from the product.
CAUTION
Risk of injury! Loss of control over the combihammer.
▶ Check that the side handle is fitted correctly and tightened securely. Check that the clamping band is
engaged in the groove provided on the tool.
1. Release the side handle clamping band by turning the handle grip.
2. Slide the side handle clamping band over the chuck from the front and into the recess provided.
3. Set the side handle to the desired position.
4. Tighten the side handle clamping band by turning the handle grip.
2201899
*2201899*
Printed: 06.06.2018 | Doc-Nr: PUB / 5434400 / 000 / 00
2
3
TE 60-A36
36 V
8.1 kg
(17.9 lb)
8.1 J
1/2 in ... 1 9/16 in
1 9/16 in ... 3 1/8 in
1 3/4 in ... 4 in
1 1/2 in ... 4 in
1/4 in ... 1/2 in
13/32 in ... 1 1/4 in
TE­Y
English 7