Publicité
Les langues disponibles
Les langues disponibles
Suspected malfunctions are often due to causes that the users can fix themselves. Therefore, check the product using this
section. In most cases the problem can be solved quickly.
PROBLEM
Product does not
start.
Tool operates
slowly.
Performance
decreases
over time.
Excessive noise.
Overheating
WWW.SENIXTOOLS.COM
TROUBLESHOOTING
POSSIBLE CAUSE
The switch trigger is locked
Battery pack not properly attached
Battery pack completely discharged
Forcing tool to work too fast.
Battery power is too low.
Blade is dull or damaged.
Battery pack reaches its life cycle.
Internal damage or wear. (bearings, for
example.)
Forcing tool to work too fast.
Blade dull or damaged.
Blocked motor housing vents.
SOLUTION
Unlock the switch trigger by trigger lock.
Attach properly.
Charge the battery pack.
Allow tool to work at its own rate.
Charge the battery pack.
Keep blades sharp. Replace with a new one if
necessary.
Replace with a new one.
Have technician service tool.
Allow tool to work at its own rate.
Keep blades sharp. Replace as needed.
Blow dust out of motor using compressed air.
17 - EN
Publicité
