Westinghouse WSnow18c Manuel D'utilisation page 13

OPERATION
CONNECTING TO POWER SUPPLY
See Figure 11.
This product is designed with a cord retainer that prevents
the extension cord from coming loose while in use.
z Form a loop at the end of the extension cord.
z Insert the loop of the extension cord through the bottom
opening ot the power cord retainer.
z Place the loop over the hook. Lightly pull on the cord to
reduce the slack and secure it over the hook.
z Plug the snow blower into the extension cord.
NOTE: Removing all excess cord slack will prevent the
plug from loosening from the extension cord.
STARTING AND STOPPING THE SNOW
BLOWER
See Figure 12.
To start the motor:
z Connect the snow blower to power supply.
NOTICE
Always secure extension cord to the
unit by using the power cord retainer. Failure to use
the power cord retainer may result in damage to the
snow blower and/or extension cord.
z Press and hold the start button.
z Pull and hold the bail against the handle to start the unit.
Release the button but continue holding the bail to the
handle.
To stop the motor:
z Release the bail.
ADJUSTING THE DISCHARGE CHUTE
See Figure 13.
The chute can be adjusted from left to right to change the
direction the snow is thrown.
z Rotate the chute adjustment handle counterclockwise to
direct the snow to the left of the unit.
z Rotate the chute adjustment handle clockwise to direct
the snow to the right of the unit.
OPERATING TIPS
WARNING
zen lakes, rivers, or similar surfaces. Death or serious
injury could occur if the ice breaks.
WARNING
rooftop or other unstable surface, which can result in
death or serious personal injury
WARNING
which can cause the operator to slip and fall, resulting
in possible serious personal injury.
Never use snow blower on fro-
Never use the snow blower on a
Do not use snow blower on ice,
FIG. 11
A
A - Power cord retainer
B - Extension cord
FIG. 12
A
A - Start button
B - Bail
FIG. 13
A
A - Chute adjustment handle
|
13
English
B