Westinghouse WSnow18c Manuel D'utilisation page 12

ASSEMBLY
INSTALLING THE DISCHARGE CHUTE
CONNECTING ROD
See Figure 10.
z Loosen but do not remove the screw on the chute rod
connector of the snow blower.
z Insert the lower chute adjustment rod and align the holes
on the connector and tab.
z Tighten the screw securely.
z Remove the screw in the top barrel of the lower chute
connector rod.
z Insert the upper chute adjustment handle through the eye-
let in the lower handle and into the barrel on the lower rod.
z Align the screw holes, reinstall the screw, and tighten
securely.
z Once assembly is complete, secure the power cord from
the switch to the snow blower to the right side of the lower
handle tube with the two cord clips.
OPERATION
WARNING
ucts to make you careless. Remember that a careless
fraction of a second is sufficient to inflict serious injury.
WARNING
side shields marked to comply with ANSI Z87.1. Fail-
ure to do so could result in objects being thrown into
your eyes resulting in possible serious injury.
WARNING
accessories not recommended by the manufacturer of
this product. The use of attachments or accessories
not recommended can result in serious personal injury.
Do not allow familiarity with prod-
Always wear eye protection with
Do not use any attachments or
FIG. 10
C
B
A
A - Chute rod connector
B - Lower chute adjustment rod
C - Cord clips
D - Barrel
E - Screw
F - Eyelet
G - Upper chute adjustment rod and handle
NOTICE
product for damaged, missing, or loose parts such as
screws, nuts, bolts, caps, etc. Tighten securely all fas-
teners and caps and do not operate this product un-
til all missing or damaged parts are replaced. Please
contact customer service or a qualified service center
for assistance.
WARNING
from power supply when you are assembling parts,
making adjustments, cleaning, or when not in use.
This will prevent accidental starting that could cause
serious personal injury.
|
12
English
G
F
E
D
Before each use, inspect the entire
Always disconnect snow blower
A