Publicité
Les langues disponibles
Les langues disponibles
Charging the Earbuds
1. Earbuds will charge if properly seated in the case
and a charged REDLITHIUM™ USB battery
pack is inserted. The earbuds indicator lights will
illuminate when proper contact for charging has
occured.
If case is plugged into a power source without a
battery pack, the earbuds will charge and case
charge indicator light will illuminate flashing red/
green.
NOTE: Misaligned ear wings/bands may cause the
earbuds to shift in the case. Always ensure proper
charging contact to the earbuds before closing the
case.
The earbuds indicator lights while charging will
display:
Red Solid:
Yellow Solid:
Green Solid:
2. Removing the earbuds from the case will display
the current battery charge on the earbud indica-
tor lights.
The earbuds indicator lights will display:
Red Flashing: 0-3% charged
Red Solid:
Yellow Solid:
Green Solid:
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery from Case
To remove, twist the cap counterclockwise away from
the lock
. Remove the case battery pack. Twist the
cap on toward the lock position.
To insert the battery, twist the cap counterclockwise
away from the lock
up the arrows on the case. Twist the cap on toward
the lock position.
NOTE: Earbud batteries are non-removeable and
non-replaceable.
0-49% charged
50-99% charged
100% charged
3-10% charged
11-49% charged
50-100% charged
. Insert the battery pack lining
Only use accessories specifically
WARNING
recommended for this tool. Others
may be hazardous.
Installing/Removing Ear Wings/Bands
Ear wings/bands help provide a secure fit. Ear wings/
bands are optional.
To install ear wings/bands:
Make sure to put the respective side on the correct
earbud. Each ear wing/band has a L or R engraved
to match the earbud engraving. The notch indenta-
tion on the earbud corresponds to the notch on the
ear wing/band.
Notch
To remove ear wings/bands:
Pull ear wing/band off the earbud.
OPERATION
Only use accessories specifically
WARNING
recommended for this tool. Others
may be hazardous.
Misuse, improper fit, or failure to wear hearing
protectors during all exposure may result in
hearing loss or injury.
Rapid removal may damage the eardrum. For
greater control and safety, remove ear tip slowly
with twisting motion to gradually break the seal.
Inspect before use and discard if ear tip silicone/
foam tips are cracked, torn, dirty, hard, or de-
formed. Earbuds should be clean and soft before
use. Damaged earbuds could break in ear canal.
Wash hands before use. Use clean earbuds.
Fitting Ear Tips
Before first use, remove the adhesive film from the
earbud charging contacts.
1. To remove ear tips, gently pull the tip away from
the earbud. To install ear tips, push tip onto earbud
until snug.
2. Inspect ear tips before use.
For silicone banded tip:
• Position ear tip in the desired wearing position.
• While pulling ear outward and upward with
opposite hand, insert ear tip into ear canal.
Adjust for best noise reduction.
For foam tip:
• Gently roll the foam tip between thumb and
fingers slowly increasing pressure until earbud is
compressed into a thin, smooth cylinder.
• Pull the outer ear up and back with one hand,
and insert the ear tip into the ear canal with the
other hand.
• Hold the earbud in place for at least 40 seconds,
allowing the ear plug to expand down into the
ear canal.
5
Notch indentation
Publicité
