Domo DO522S Mode D'emploi page 29

www.domo-elektro.be
use the food board and pressure plate, unless the size
and shape of the piece to be cut do not allow it.
• After using and before cleaning the appliance, always
set the cut thickness adjustment and the safety button
to "0".
ONDERDELEN
1. On/off switch
2. Blade: ø 22 cm
3. Food sled
4. Button to remove
food sled
5. Press plate
6. Slice thickness knob
INSTRUCTIONS FOR USE
1. Place the slicing machine on a flat, stable support, in order to prevent it from
sliding away.
2. Make sure that on/off switch is switched off before putting the plug into the
socket. Use an alternating current plug, which is suitable for the voltage shown on
the appliance (230V~ 50Hz).
3. Set the desired slice thickness by turning the knob. The slice thickness can be set
from 0 to 15 mm. After each use, set the slice thickness knob back to 0. The slicer
can be used to slice meat, bread, vegetables or cheese.
4. Place the food onto the food sled.
5. Switch on the on/off switch to spin the blade.
Caution: Be extra careful while slicing.
6. Slice the food by pushing the food sled forward. Use the press plate to push the
food against the blade. Always slice the food using the food sled and if possible
the press plate to avoid the risk of injuries. The forward movement should last
for about 2 to 3 seconds. The backward movement should last at least as long (3
seconds or longer).
1
29
2
4
3
DO522S
5
6