Buffalo Bain Marie 600 Serie Mode D'emploi page 4

EN
Installation
The "bain marie" should be placed on a solid level
surface. The thermostat should be set to the off
position (0).
Note: Before using for the first time, clean
all parts well. Let dry completely.
Operation
Pot with lid
Drainage tap
Heating indicator light
1. Fill the tank with water to a level between
the 'MIN' and 'MAX' marks on the inside of
the tank. Ensure the water level touches the
bottom on the pots being used.
Note: BUFFALO recommend that fresh
water should be used each time.
2. Connect the appliance to the power supply.
3. Set the thermostat to the desired temperature.
The heating indicator will light up and the
appliance begins to heat the water.
4. When the set temperature is reached, the
heating indicator light turns off.
Note: During use, the heating indicator will
•
cycle on/off, indicating the set temperature is
being maintained.
4
FU291_ML_A5_v1_20240306.indb 4
5. Put the pots with food into the water tank.
6. After use, set the thermostat to "0" (OFF
position) and disconnect the appliance from
power supply.
WARNING: Do not allow the water to drop
below the 'MIN' level during operation.
Otherwise, severe damage to the heating
element could result.
WARNING: The food and water are very
hot! Take care when removing the pots
0
from the bain marie.
90 30
Maintaining Water Levels
80 40
It is important to regularly check the water level in
70 50
the tank.
60
• Always keep the water level above the
'MIN' mark on the inside of the tank during
operation.
• Damage to the heating element can occur if
the tank boils dry and the element may have
to be replaced. This is not covered by the
BUFFALO warranty.
Emptying the Appliance
Note: Always switch the appliance off and
Thermostat
allow the water to cool before emptying.
Turn on the tap to drain the water. Ensure a
suitable container is used to collect the water.
Thermal Cut-Out Reset
This appliance is fitted with a Thermal Cut-Out
safety feature. Should the temperature exceed safe
levels the appliance will automatically cut power.
The thermal Cut-out switch is located on the rear
of the appliance. To reset the appliance after a
sufficient cool-down period:
1. Unscrew the reset switch cover.
2. Press the small reset switch down until it clicks,
using a blunt pointed instrument.
3. The appliance is now reset and can be used as
normal.
2024/3/6 10:37:35