Publicité
Les langues disponibles
Les langues disponibles
Number
1
2
3
4
5
6
7
8
9
10
5. Initial use
Take the device out of the package and remove all the packaging material. Insert a
"CR2032" battery (not included in the scope of supply) into the battery compart-
ment at the back, which is located at the bottom. Pay attention to the correct po-
larity of the contacts. This battery is used for saving a backup of the time and alarm.
6. Setting the time
Once the device is connected to a properly installed socket, press and hold the "SET"
button for about 3 seconds to adjust the time. Use the "UP" and "DOWN" buttons to
increase or decrease the values. Press "SET" once again to continue with the settings.
The setting cycle is as follows:
1. Hour
2. Minute
3. 12/24 Hours
4. Snooze time (select a snooze time from 5 minutes to 60 minutes)
Press the "SET" button to complete the settings, or wait for about 20 seconds.
14
Name
Projector
Time display
Stand
"DOWN" button
"VOL" button
"RADIO/SLEEP" button
"SNOOZE/DIMMER" button
"SET" button
"AL" button
"UP" button
English
Publicité
