Publicité
Les langues disponibles
Les langues disponibles
2. ASSOCIATION OF A CHANNEL WITH A RECEIVER
With this procedure, the channels created are associated with the receiving control unit that you want to control.
2.1 ASSOCIATION OF A CHANNEL WITH A BUTTON IN THE RECEIVER
Requirements: access the programming area of the control unit
PROCEDURE
1 - Activate the receiver on which you want to program the transmitter (see the receiver manual).
2 - With the "circle" key select the channel you want to associate
3 - Send the command with the "square" button
2.2 ASSOCIATION OF A CHANNEL TO A RECEIVER NEAR THE CONTROL UNIT USING A PRE-PROGRAMMED TRANSMITTER
Requirements: Have a compatible transmitter (see transmitter manual) already programmed on the control panel.
PROCEDURE
1 - Take up position near to the receiver
2 - With the transmitter already programmed, choose the channel associated with the receiver and press
the "up arrow" and "down arrow" keys at the same time for 3 seconds (the transmitter will start to flash).
The receiver that the transmitter channel has been programmed on is activated for 30 seconds.
3 - Send a command with the new transmitter that you want to programme (see transmitter manual for
use).
WARNING: Once the signal has been received from the new transmitter, the control unit will go back to
normal operation; if you want to programme other transmitters repeat the procedure.
2.3 DELETION OF THE CHANNEL FROM THE RECEIVER
To eliminate a transmitter from the memory of a control unit, it is necessary to carry out the
procedure on the control unit itself, see control unit manual
3. ACTIVATION OF THE WIFI LISTENING OF A CONTROL UNIT
Requirements: Have a compatible transmitter (see control unit manual) already programmed on the control unit.
PROCEDURE:
1 - Take up position near to the receiver
2 - With the transmitter already programmed, choose the channel associated with the receiver and press
the "%" and "square" keys at the same time for 3 seconds (the transmitter will start to flash). The receiver
that the transmitter channel has been programmed on is activated for 30 seconds.
3 - The receiver on which the transmitter was programmed emits beeps to signal the WiFi reset
Within three minutes, pair with the OneSmart application.
If the control unit is not associated, the WiFi returns to stand-by
12
1
2
3
4
5
6
1
2
3
4
5
6
Publicité
