Rivers Edge Treestands RETREAT-LS RE670 Manuel D'utilisation page 3

READ AND UNDERSTAND THE FOLLOWING WARNINGS BEFORE ASSEMBLY
STOP
MODEL RE670
MAXIMUM USE HEIGHT - 17' 11" TO SHOOTING RAIL
MAXIMUM OCCUPANCY - ONE (1)
TOTAL WEIGHT LIMIT - 300 LB
TREE DIAMETER RANGE - 12" TO 30"
WARNING
This product carries strict height and weight restrictions.
Do Not use this product if you exceed the total weight
limit. Please note that the total weight limit includes the
user(s) and their equipment.
WARNING
When hunting from, installing, or removing a
treestand, tripod, or tower, falls can occur any time
after leaving the ground causing injury or death.
When using, installing, or removing a treestand, always
wear a fall arrest system (FAS) comprising a full body
harness at all times after leaving the ground. You must
stay connected at all times after leaving the ground
while climbing treestands, and while using, installing,
or removing hang-on treestands. Single safety belts and
chest harnesses are no longer allowed and shall never be
used. When using, installing, or removing a treestand, if
you are not wearing a full body harness properly attached
to the tree that is protecting you from a fall, do not leave
the ground.
Read and understand all of the manufacturer's Warnings
and Instructions and use all safety devices provided by
the manufacturer. Contact the manufacturer for any
questions. Failure to do so could result in injury or death.
Never exceed the total weight limit of the treestand.
Never use, install, or remove a treestand, tripod, or
tower during inclement weather such as rain, lightning,
windstorms or icy conditions and end your hunt and return
to the ground if inclement conditions arise.
Never use, install, or remove a treestand, tripod, or tower
while using drugs (even prescription drugs) or alcohol.
Never use, install, or remove a treestand, tripod, or tower
while feeling ill, nauseous or dizzy, or if you have a prior
medical condition that could cause a problem, that is,
heart condition, joints that lock-up, spinal fusions, etc., or
if you are not well rested.
Never sleep in a treestand.
Check for parts online at www.HuntRiversEdge.com or call 800-345-6007
RETREAT™ — LS Ladder Stand
WARNING
Never use, install, or remove a treestand on a dead,
leaning, diseased or loose barked tree, or a utility pole.
Always avoid electrical power lines.
Never rely on a tree branch for support.
Never jump or bounce on a treestand to seat it to the tree.
Pull up a bow, backpack, or firearm or other equipment
only after being secure in the treestand and a firearm
must be pulled up with it unloaded, chamber open, and
muzzle down.
Always inform someone of the hunting location, where
the treestand will be located and the expected duration
of the hunt.
A signal device such as a mobile phone, radio, whistle,
signal flare or personal locator device (PLD) must be on
your person and readily available at all times.
Never leave a treestand in a tree for more than two weeks
since weather or animals could cause damage. Tree
growth can also stress and damage straps and buckles.
Inspect the treestand and all safety devices each time
before use and Do Not store a treestand outdoors when
not in use.
Never modify your treestand in any way by making
repairs, replacing parts, or altering it except if explicitly
authorized in writing by the manufacturer.
Practice installing, adjusting, removing, and using your
treestand at ground level prior to using it at elevated
positions. Study your new stand to become familiar with
all of its features and design. Doing so will confirm that
the product is manufactured, assembled and installed
correctly.
Instructions (written and video) shall be kept in a safe place
and reviewed at least annually. It is the responsibility of
the treestand owner to furnish the complete instructions
to any person who borrows or purchases the treestand.
Use at least three (3) people to install or remove/take
down a ladder treestand.
The criss-cross straps/ropes and stabilization devices
must be attached before climbing to the platform.
When installing a ladder stand, always bounce on the
first rung to set the ladder into the ground according to
manufacturer's instructions before proceeding to climb
any higher.
Check every ladder section connection every time you
use the stand before you leave the ground. If ladder
sections are separating, do not use the stand.
Operator's Manual
3