Rivers Edge Treestands RETREAT-LS RE670 Manuel D'utilisation page 13

Operator's Manual
RETREAT™ — LS Ladder Stand
11. Before uprighting the stand to the tree, you must attach
the two long straps (45) to the assembled treestand. Begin
by feeding one end of each strap through the three strap
guides (28) and strap guards (27) under the seat side rail
and at the top of the ladder on both sides. SEE FIGURE 1
and DETAIL A.
Attach the looped ends of the straps together near the
center of the ladder with the carabiner on the end of the
tether rope (43). SEE FIGURE 1 and DETAIL B.
Run the opposite end of each strap down to the ladder
ratchet (22) on either side of the ladder. Run the strap
down through the center slot in the ratchet and "ratchet"
just enough to loosely hold the strap in place. They do not
27,28
need to be tight. This is only temporary to keep them out
of the way while you upright the stand to the tree. SEE
FIGURE 1 and DETAIL C.
Lastly, run the tether rope (43) down the length of the
ladder and loosely tie off the remaining rope near the
ladder ratchets (22). SEE FIGURE 1 and DETAIL C. You are
now ready to upright the ladder. Follow setup and use
instructions on following pages.
27,28
45
43
Carabiner
FIGURE 1
13
Check for parts online at www.HuntRiversEdge.com or call 800-345-6007