Installation Instructions; The Refrigerator - GE 21 Série Manuel D'utilisation Et D'installation

Installation
Instructions
Questions? Call 800.GE.CARES (800.432.2737)
In Canada, call 1.800.361.3400
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
•
instructions for local inspector's use.
IMPORTANT –
•
governing codes and ordinances.
Note to Installer –
•
instructions with the Consumer.
Note to Consumer –
•
for future reference.
• Skill level – Installation of this appliance requires
basic mechanical skills.
• Completion time – Refrigerator Installation
15 minutes
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
WATER SUPPLY TO THE ICEMAKER
(ON SOME MODELS
If the refrigerator has an icemaker, it will have to be
connected to a cold water line. A GE water supply kit
(containing tubing, shutoff valve, fittings and
instructions) is available at extra cost from your dealer,
by visiting our Website at www.GEAppliances.com (in
Canada at www.geappliances.ca) or from Parts and
Accessories, 800.626.2002 (in Canada 1.888.261.3055).
REFRIGERATOR LOCATION
• Do not install the refrigerator where the temperature
will go below 60°F (16°C) because it will not run often
enough to maintain proper temperatures.
• Do not install the refrigerator where the temperature
will go above 100°F (37°C) because it will not perform
properly.
• Install it on a floor strong enough to support it fully
loaded.
Save these
Observe all
Be sure to leave these
Keep these instructions
)
or
Visit our Website at:
www.geappliances.ca
or
Visit our Website at:
CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation and plumbing and electrical
connections:
21' and 23'
• Sides 1/8" (4 mm)
• Top 1" (25 mm)
• Back 1/2" (13 mm)
ROLLERS
The rollers have 3 purposes:
Rollers adjust so the door closes easily when opened
about halfway. [Raise the front about 5/8" (16 mm) from
the floor.]
Rollers adjust so the refrigerator is firmly positioned on
the floor and does not wobble.
Rollers allow you to move the refrigerator away from the
wall for cleaning.
Final leveling adjustments should be made after the
refrigerator has been installed.
To adjust the rollers on 25', 27', and 29' models:
Turn the roller
adjusting screws
clockwise to raise

the refrigerator,

counterclockwise to
lower it. Use a 3/8"
hex socket or wrench,
or an adjustable
wrench.
24
Refrigerator
Models 21, 23, 25, 27 & 29
www.GEAppliances.com
25', 27', and 29'
1/8" (4 mm)
1" (25 mm)
1" (25 mm)
Roller adjusting screw