cosi burner square Manuel D'utilisation Et D'installation page 14

2. Placing lava rocks and optionally ceramic logs
If the Cosi built in burner is installed properly, you can place the lava rocks and optionally ceramic logs (not
included, separately available) on the top. Every Cosiburner is supplied with small and large lava rocks. Take the
small lava rocks without grit and place these gently on the model. Repeat the process with the big lava rocks and
make sure the burner is covered with lava rocks. Keep the space around the ignition unit free of lava rocks and
ceramic logs (see image below).
If you place ceramic logs, it is recommended to place them as follows:
Ignition unit
Cosiburner square Cosiburner straight
Make sure the fire ring is only minimally covered by the logs. If the logs block the fire ring, dangerous situations
may occur. The blockade of the fire ring will affect the air flow of the ring and the flames will be different. This
results in dangerous situations!
If you want to order more lava rocks or ceramic logs, this is possible at your purchase address.
Pay Attention: When you are going to use the Cosi built in burner for the first time, make sure that the device is
turned at the highest setting for 15 minutes. In this way, the lava rocks are heated through and this ensures that
any bumps or air bubbles will disappear from the lava rocks. During the first time the Cosiburner is turned on or
when the lava rocks have been wet (after some rain), keep at least two meters away from the burner and also
ensure that no flammable materials are placed around or on the table within this radius of two meters. Because
the air bubbles are burned from the lava rocks, the rocks can jump up during the first time / when lava rocks
have been wet and possibly come out of the burner.
When you want to move or clean up the lava rocks and ceramic logs, always make sure that they have cooled
down completely.
The lava rocks and logs can scorch black in time. This has to do with soot formation which always occurs in devices
that show a yellow flame. This soot can be removed by blowing / vacuuming with an ash vacuum cleaner. The
soot may also be brushed off with a dry brush.
3. Placing the gas bottle
Cosi built in burners are only tested and legal with propane gas. Make sure you bought a propane gas bottle.
Make sure the gas bottle stands stable on a non-flammable surface.
The supplied hose has a length of 1.5 m. Therefore, the gas bottle should be placed at a maximum distance of 1
meter away from the built-in burner. People, children and pets can trip over the hose, so place the hose outside
of the walking area, where children and pets can't reach it. Connect the gas bottle to the supplied pressure
14