Publicité
Les langues disponibles
Les langues disponibles
RGB LED - Instructions for Remote:
This remote has 17 buttons in total:
Turn on/off switch.
Automatic play key, press this key and each dynamic mode will run three times.
Switch to static color mode from dynamic mode and change the static color
forward/reverse direction.
Switch to Static color mode from dynamic mode, and change the brightness
it has 5 levels.
Switch to dynamic mode from static color mode, and change the dynamic
mode to forward/reverse direction.
Switch to dynamic mode from static color mode and change the speed
in forward/reverse direction, it has 10 levels.
Press the color key whilst in any mode to jump to the corresponding seven
static color modes.
Instructions to match Remote to controller:
Power on controller, within 3 seconds, press
will flash 3 times when it has matched succesfully, it will only match the
code 1 time before powering off. If you need to match the code again,
restart the procedure by powering the controller/ LED lamps off again.
Default output:
If the LED lamp color order is different (the color button does not match the LED color)
the user can adjust the output line order by carrying out the following steps:
1} Long press the white button until the load light flashes. At this moment,
if you press other buttons on the remote control, nothing will happen.
2} Press the red button to switch colors until the load light turns green.
3} Press the green button again to switch colors until the load light turns green.
4} Finally, press the white button for 3 times to exit the line sequence setting
mode, and the line sequence setting is completed
5} Based on the premise that the line order is RGB, the mode table is as follows:
LED LIGHTING CONTROLS
key , the load light
Remote dimensions
Specifications:
-
Output: 3 channels
-
Connection mode : common anode
-
Controller dimension: 1.70xw40xh40mm
-
Remoter dimension: 1.85.9xw39.6xh6.9mm
-
Packing size: 1.200*w147mm
-
Net weight: 95 g
-
Gross weight: 140 g
-
Static power : <0.5w
-
Output current: <4a{each channel}
-
Output power: 12v<144w, 24v<288w
Controller Dimensions
The power input terminal:
Red wire connected to the postitive terminal
and black wire connected to the negative terminal.
The red, green and blue output terminals are connected to
RGB and the black terminal is connected to the positive
terminal.
26/27
25/27
Publicité
