Toshiba ST-S30 Manuel Du Propriétaire page 4

TUNED indicator
Lights when a radio broadcast is precisely tuned.
Notes:
When the unit is not going to be used over a long period
of time, the power cord should be unplugged. Note, how-
ever, that if backup batteries are not used, memory contents
will be lost if the unit is unplugged.
Consequently, always
be sure that the memory preservation batteries are in place
before unplugging this unit.
2
Note:
(Operations
= Auto Tuning
1. Press the AUTO button ©).
2. Press the UP or DOWN (3 button. The frequency will auto-
matically increase or decrease until a station of sufficient
strength is reached. To stop the frequency before such a station
is reached, press the manual button ©.
= Manual Tuning
. Press the MANUAL button@).
2. Press the UP or DOWN button 43 to tune in the desired fre-
quency. The tuned frequency changes in 0.05 MHz steps in the
FM band, 9 kHz in the AM (MW on the ST-S30L) band and
1 kHz in the LW (ST-S30L only) band. Hold either button
down to continuously increase or decrease the tuned frequency.
—
Direct Tuning
Press the DIRECT button @).
Enter the desired frequency with the numeric keys Q).
Press the ENTER button (0 to tune in that frequency.
ON> ff
Notes:
@ The word 'ERROR' is displayed if the entered frequency is out-
side the selected band. .
e If the entered frequency does not exactly match the tuning
step frequencies, the nearest tuning step frequency immediately
below the entered frequency will be tuned. For example, if
FM 100.11 MHz is entered, 100.10 MHz will be tuned.
e Press the CANCEL button @) before the ENTER button is
pressed to cancel the direct tunig mode.
e@ if you make a mistake when entering the frequency, press the
DIRECT button @ again and reenter the frequency
= Preset Tuning
The ST-S30 and ST-S30L are equipped with a presettuning func-
tion that stores the exact frequencies of up to ten shtions. Once
a station has been stored in the memory, it can be ncalled in an
instant by pressing the corresponding preset channel button. Old
stations can be replaced with new ones any number of times by
simply storing the new frequency where the old one was stored.
Perform the following procedure to store a station is one of the
preset channels.
1. Tune in the desired station.
2. Press the MEMORY button @).
3. Press the preset channel button Q) of the chanm! where the
station is to be stored.
Up to ten frequencies can be stored in this manne for instant
recall at any time. Note that only one frequency canbe stored by
each preset channel button.