Procedures In The Event Of Faults - Calira EVS 36/20-DS/IU Mode D'emploi

Procedures in the event of faults

The device is maintenance-free. However, if any faults do
occur, please proceed according to the following table:
36
Fault Action
The device is not – Check the circuit breaker and
working.
The battery is not being – Check all connections from
charged.
12 V circuits are not – Check the fuses and replace
being supplied.
– Check the connections to the
The battery II is not – Check the connection of the
charged in driving mode.
The voltage of the – Start the motor and let it run
battery II has dropped to
below 1.5 V; the mains
charging process does
not start.
The maximum charging – The device overheats. Ensure
current is not reached.
None of the faults Please contact the manufacturer.
described here seems to
apply. But the device still
does not work.
the mains connection.
the charger to the battery. Pay
attention to the correct polarity.
Unplug the mains plug of the
device and reinsert it.
them if necessary.
affected circuits.
line D+ from the dynamo and
the fuses.
for approx. 30 seconds. battery
voltage rises above 1.5 V.
The charging process starts
automatically.
better ventilation of the device.