INSTALLING BATTERY
Insert 2 "AAA/ UM4" batteries to the remote control prior to use. Make sure to match their
polarities (+/-) to the markings inside the compartment.
NOTES:
- Before throwing any batteries away, consult your distributor who may be able to take them
back for speci昀椀c recycling.
- If the remote control is not going to be used for a long time, remove the battery to avoid damage
caused by battery leakage corrosion.
- Never recharge the batteries, apply heat to them or take them apart.
- Attention should be drawn to the environmental aspects of battery disposal.
- Do not throw batteries in 昀椀re!
- Battery shall not be exposed to excessive heat such as sunshine, 昀椀re or the like.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same
or equivalent type.
ACCESSORIES
Remote Control x 1
AC adaptor x 1
POWER SUPPLY
Using the AC adaptor
The supplied AC adaptors are suitable for use on AC mains supplies of 100-240V
and should only be connected to a mains supply within these parameters.
Cautions:
• The AC adaptor included with this unit is for its use only. Do not use it with other equipment.
• Turn o昀昀 the unit before unplugging the AC adaptor from the unit so as to avoid the unit being
damaged.
• When the unit is not going to be used for long time, disconnect the AC adaptor from the AC outlet.
• Be sure to use it near the wall outlet and easily accessible. If a malfunction occurs, disconnect
the plug from the wall outlet at once.
• AC adaptor is used as the disconnect device. It shall remain readily operable and should not
be obstructed during intended use. To be completely disconnected the apparatus from supply
mains, the AC adaptor of the apparatus shall be disconnected from the mains socket outlet
completely.
• Never use an AC adaptor that is damaged, route power lead in a safe manner and make sure
it is not subjected to trapping or pinching. If the power lead is damaged refer to a quali昀椀ed
service agent.
DVD-5189 IB MUSE 001 REV3_20230907.indd 10
DVD-5189 IB MUSE 001 REV3_20230907.indd 10
50/60Hz
GB - 3
CONNECTIONS
Watching a DVD on your TV (AV cable not included)
Note: Make sure to use the cable with correct plug.
DISC PLAYBACK
Region Management Information
Region Management Information: This unit is designed and manufactured to respond to the
Region Management Information that is encoded on DVD discs. If the Region number printed on
the DVD disc does not correspond to the Region number of this unit, this unit cannot play that disc.
The region number of this unit is 2.
Basic Playback
1. Press
button to turn on the unit.
2. Press
button on the unit to open the disc door.
3. Insert a disc with label face you.
4. Close the disc door. It takes a short while for your unit to load the disc. After loading, the unit
will automatically bring you to the main menu of the DVD or start playing the DVD. If the unit
does not automatically start playing the DVD, press the
Accelerated play
While the disc is playing, press
one or more times to vary the speed and direction of
or
to resume normal playback.
the accelerated play. Press
.
GB - 4
2023/9/7 11:10:25
2023/9/7 11:10:25