FreezyBoy ONE Mode D'emploi page 24

15.4
18
18
9.5
9.5
46
Space required by FreezyBoy ®
with raiser
Width: 18 cm (17.0 cm plus 1 cm)
Depth: 42 cm (37.0 cm plus 5 cm)
Height: 40.5 cm
Space required by FreezyBoy
®
without raiser
Width: 18 cm (17.0 cm plus 1 cm)
Depth: 42 cm (37.0 cm plus 5 cm)
Height: 37.5 cm
Setup instructions
1. Remove all parts from the drawer pull-out and
clean it.
2. Extend the pull-out as far as you can.
3. Check the height of your waste bin if you are
planning to fit FreezyBoy beside it. If your
®
waste bin is higher than FreezyBoy ® , you can
use the raiser supplied with your newappliance.
4.a) If using raiser: Place the raiser on the base of
the pull-out, 9.5 cm to the right of the centre of
the front panel.
Position it so that the short end with the tab
touches the front panel. Screwin the raiser.
b) If not using raiser: Position the mounting
plate on the base of the pull-out, 9.5 cm to the
right of the centre of the front panel. Position it
so that one of the long ends touches the front
panel. Screwin the mounting plate.
5. Place FreezyBoy ® on the floor next to
the pull-out.
6. Clip the cable clamp onto the cable, 80 cm
down from the appliance (measure this
distance).
7. Screwthe cable clamp (with cable) onto the
42
right inside wall of the base unit. Ideally, the
clamp should be 35 cm above the bottom of
the pull-out and 42 cm back from the outside
edge of the base unit.
8.a) If using raiser: Place FreezyBoy
Make sure that all four of the rubber feet are
positioned securely in the round holes on the
raiser.
b) If not using raiser: Place FreezyBoy
mounting plate.
Make sure that the front two rubber feet are
positioned securely in the round holes on the
mounting plate.
9. Connect FreezyBoy
10. If using FreezyBoy
Place the waste bin in the pull-out beside
FreezyBoy
to the base of the pull-out, positioning one
bracket in front of the waste bin and the
other behind it.
on the raiser.
®
on the
®
to the power supply.
®
® with a waste bin:
. Screwthe support brackets
®
47