Télécharger Imprimer la page

Danby DDR050BJ2WDB-ME Manuel Du Propriétaire page 12

Publicité

Les langues disponibles

Les langues disponibles

OPERATING INSTRUCTIONS
OPERATION
• Place the dehumidifier on a smooth, level floor
that is strong enough to support it with a full
bucket of water.
• Do not place the dehumidifier on carpeting as
this can block air flow. Do not force casters
to move over carpeting as the appliance can
become unbalanced and spill water.
• To maintain efficiency, operate the appliance
in an enclosed area. Keep nearby doors and
windows closed.
• Maintain a minimum clearance of 40 cm (16
inches) around the air outlets and 20 cm (8
inches) on other sides of the appliance to allow
for proper air circulation.
• The recommended ambient operating
temperature is between 5°C (41°F) and 32°C
(90°F).
• Any time the appliance is placed on its back or
side, it must be allowed to stand upright for 6
hours before plugging in to avoid damage to
internal components.
• The default humidity setting is 40% and high fan
speed. Depending on humidity conditions the
dehumidifier may not start automatically under
the default setting. This means the humidity in
the surrounding air is less than 40%. Press the
down button to lower the set humidity until the
set humidity is lower than the ambient humidity.
• For optimal performance, ensure that the
humidity setting is 10% lower than the ambient
humidity. It is normal for the ambient humidity to
vary up to 5% above or below the set humidity.
• It is recommended in normal conditions to set
the humidity between 40-45%.
• It is normal for the dehumidifier to exhaust warm
air from the air outlet.
• The power cord storage band can be found
in the water bucket and it can be installed by
pressing it onto the back of the cabinet until it
clicks.
TIMER
Auto Off
1. When the dehumidifier is turned on, press the
timer button to activate the auto off timer.
2. Press the humidity adjust buttons to change the
set time in 0.5 hour increments up to 10 hours
and then in 1 hour increments up to 24 hours.
Auto On
1. When the dehumidifier is turned off, press the
timer button to activate the auto on timer.
2. Press the humidity adjust buttons to change the
set time in 0.5 hour increments up to 10 hours
and then in 1 hour increments up to 24 hours.
Using Auto On and Auto Off Together
The auto on and auto off timers can be used at the
same time by first setting one and then the other.
For example, if the dehumidifier is running, you can
set the auto off timer to let it run for a set amount
of time before turning off and then set the auto on
timer to turn it back on at a later time.
Or, if the dehumidifier is not running, you can set
the auto on timer to turn it on at a later time and
then set the auto off timer to shut it off after running
for a period of time.
Note: The timer will not cycle the dehumidifier on
and off indefinitely. The auto on and auto off timers
will function one time and then the dehumidifier will
return to regular functioning.
Turning the dehumidifier on or off at any time or
changing the timer setting to 0.0 will cancel the
timer settings.
11

Publicité

loading