Power Fist 9244955 Manuel D'utilisation page 10

9244955
Not inflating
Pressure rod
not rising
Pressure rod
not lowering
10
1.4 Ton 12V Hydraulic Jack
1. Function switch in
wrong position
2. Needle not connected
to tire properly
3. Air hose leaking
1.
turned on
2. Function switch in
wrong position
3. Direction switch in
wrong position
4. Environmental
temperature too cold
5. Jack has been in
storage for too long
1.
turned on
2. Function switch in
wrong position
3. Direction switch in
wrong position
4. Jack has been in
storage for too long
5. Pressure malfunction
1. Adjust function switch to
appropriate position
2. Ensure proper connection
3. Inspect and repair
appropriately
1. Ensure vehicle is
powering tool
2. Adjust function switch to
appropriate position
3. Adjust direction switch to
appropriate position
4. Bring the jack into a
warm space, allowing the
components and fluids to
warm up
5. Operate in the down
position for a minute
before attempting to lift
1. Ensure vehicle is
powering tool
2. Adjust function switch to
appropriate position
3. Adjust direction switch to
appropriate position
4. Operate in the down
position for a minute
before attempting to lift
5. Remove head of safety
valve (#9), loosen the
safety valve with the
included hex wrench until
the pressure rod falls
properly then tighten
again
For technical questions call 1-800-665-8685
V1.0