Publicité
Les langues disponibles
Les langues disponibles
Disconnect
immediately after use. Additionally it is advisable to wind
the power cord in order to ensure a better cleaning and to
avoid any risk of damage. Do not immerse the motor unit
in water or other liquids, clean it with a damp cloth only.
Do not use the appliance if the dust bin is not installed.
Do not use the product without proper filtering system
assembled: this may seriously damage the engine
avoiding the warranty. Use only on dry surfaces.
Caution when using the device on the stairs.
CAUTION: while the unit is running, do not approach
the air inlet to ears, eyes, etc., or to fragile items such
as vases, tools, electronic machines.
DESCRIPTION AP23
1. Power button
5. Handle
9. Central pivot wheel
13. Brush
C. Opening lid button
ASSEMBLING THE ACCESSORIES
Insert the hose (8) in the suction nozzle (3), pushing it until blocking. The flexible hose terminates in the
handle (10), a curved tube equipped with a hole for adjusting the air flow (11). With this controller you can
reduce or increase the suction power. Fit the telescopic tube (12) to the handle (10). The tube can be extended
pushing the black button present on the tube.
Attach the floor brush (13) (normal or parquet) or the nozzle to the extension tube. The nozzle can be oriented
horizontally or vertically depending on the type of area you need to clean and is equipped with a mini-brush.
Pull out the power cord to the desired length and plug it to the main electrical outlet.
OPERATING CONTROLS
- Power on: press the power button (1) and the device is turned on/off.
- Cable rewind: after use, unplug the appliance from the electrical outlet and press the button (2) to rewind
the power cord.
CAUTION: when rewinding the power cord, it is recommended to pick up the plug to avoid whiplash.
REMOVING THE CONTAINER
The dust bin (4) must be emptied when full of dust. In any case empty it frequently, in order to ensure good
performance of the vacuum cleaner and to prevent any leak in the air flow power.
To empty the bin, follow the instructions below:
- Grasp the handle of the dust bin (4) and press the release button of the container (A); remove the dust bin
from the unit by pulling it out.
- Bring the dust container (4) over a bin and press the release button (C) which is located on the back of the
container. This button will open the door dropping all the dirt. It is recommended to do this outdoors to
avoid soiling the house when the dust comes out of the trash.
the
plug
2. Power cord rewind button 3. Suction nozzle
6. Resting hook
10. Hose handle
A. Dust bin release button
D. Cyclone Pre-filter
from
the
7. Air outlet filter
11. Air regulator
B. Dust bin cover lid
L M are protective plastics. Remove before using.
electrical
4. Dust bin
8. Flexible hose
12. Telescopic tube
outlet
11
Publicité
