TechniSat Tareo 26 Manuel D'instructions page 40

Electronic Programme Guide (EPG)
Some, but not all channels send information about the
current and next programmes. Press the EPG button
to view the EPG menu.
Info bar commands:
RED button: Previous day.
GREEN button: Next day.
YELLOW button: Zooms to the selected programme.
Next day: displays filtering options.
BLUE button: displays filtering options.
(RECORD): the TV will start to record the selected
progamme. You can press again to stop the recording.
IMPORTANT: To record a programme, you should first
connect a USB disk to your TV while the TV is switched off.
You should then switch on the TV to enable recording feature.
Otherwise, recording feature will not be available.
NOTE: Switching to a different broadcast or source is
not available during the recording.
Programme Options
In EPG menu, press the OK button to enter the Event
Options menu.
Select Channel
In EPG menu, using this option, you can switch to the
selected channel.
Record / Delete Record Timer
After you have selected a programme in EPG menu,
press the OK button and and Options screen will be
displayed. Select "Record" option and press the OK
button. After this operation, a recording becomes set
to the selected programme.
To cancel an already set recording, highlight that
programme and press the OK button and select the
option "Delete Rec. Timer". The recording will be
cancelled.
Set Timer / Delete Timer
After you have selected a programme in EPG menu,
press the OK button and and Options screen will
be displayed. Select "Set Timer on Event" option
and press OK button. You can set a timer for future
programmes. To cancel an already set timer, highlight
that programme and press the OK button. Then select
"Delete Timer" option. The timer will be cancelled.
NOTE: It is not possible to record or set timer for two or
more individual events at the same time interval.
Recording a Programme
IMPORTANT: When using a new USB hard disk drive, it is
recommended that you first format the disk using your TV's
"Format Disk" option.
To record a programme, you should first connect a
USB disk to your TV while the TV is switched off.
You should then switch on the TV to enable recording
feature.
For using recording function, you should connect a
USB disk or an external hard disk drive to the TV and
the connected USB disk should have at least 1 GB
capacity and should have 2.0 speed compatibility.
If the connected USB device does not support 2.0
speed, an error message will be displayed.
NOTE: Recorded programmes are saved into the
connected USB disk. If desired, you can store/copy recordings
on a computer; however, these files will not be available to
be played on a computer. You can play the recordings only
via your TV.
NOTE: Lip Sync delay may occur during the timeshifting.
Timeshifting and recording features will not function
in radio channels. The TV can record programmes
up to ten hours.
Recorded programmes are split into 4GB partitions.
If the writing speed of the connected USB disk is not
sufficient, recording may fail and timeshifting feature
may not be available.
Recordings of HD programmes can occupy bigger
size on the USB disk depending on the broadcast's
resolution. For this reason it is recommended to use
USB hard disk drives for recording HD programmes.
Do not plug out the USB/HDD during the recording.
This may harm the connected USB/HDD.
Multipartiton support is available. Maximum two
different partitions are supported. If the disk has
more than two partitions, a crash may occur. The
first partition of the USB disk is used for PVR ready
features. It also must be formatted as primary partition
to be used for PVR ready features.
Some stream packets may not be recorded because of
signal problems, so sometimes the video may freeze
during playback.
Record, Play, Pause, Display (for PlayListDialog) keys
cannot be used when teletext is ON. If a recording
starts from timer when teletext is ON, teletext is
automatically turned off. Also the teletext usage is
disabled when there is ongoing recording or playback.
- 40 -