TechniSat Tareo 26 Manuel D'instructions page 30

Viewing the TV TV Control Switch & Operation
1. Up direction
Standby LED
2. Down direction
3. Programme/Volume / AV / Standby-On selection
switch
In order to change the volume of your TV set, please
move the switch upwards or downwards. If you want to
change channels, press the middle of the switch once
(Position 3) and then move upward or downward. If
you press the middle of the switch once more,source
OSD will be displayed. To select desired source, move
the switch upward or downward and release. If you
press the middle of the switch and hold about a few
seconds, the TV will switch to standby mode. Main
Power cable
menu OSD cannot be displayed via the control button.
, switch is used for turning the TV on or off.
Operation with the Remote Control
Press " " button on your remote control to display
main menu screen. Use Left or Right button to select
a menu tab and press OK to enter. Use Left / Right
/ Up / Down to select or set an item. Press " " or
" " button to quit a menu screen.
Input Selection
Once you have connected external systems to your
TV, you can switch to different input sources. Press
"AV" button on your remote control consecutively to
select the different sources.
Changing Channels and Volume
You can change the channel and adjust the volume
by using the +/- and P+/- buttons on the remote.
- 30 -