Fitting Screen And Handle; Switch From Trimmer To Brushcutter - Texas A/S BC 335-4 Manuel D'utilisation

4. Fitting Screen and Handle

Fit screen using screws supplied. Check screen is secure.
See figure 3.
Fit handle and ensure machine is balanced. Also make sure the machine is comfortable to
use for the user.
See figure 4.

5. Switch from Trimmer to Brushcutter

Removing trimmer head – figures 16, 17.
1. Insert the Allen key (1) provided into trimmer gear hole and bushing (a) to secure
the shaft.
2. Unscrew twine head clockwise.
Note! Keep trimmer head parts together for later use.
Fitting blade – figures 6, 7, 8
1. Insert the Allen key (1) provided into trimmer gear hole and bushing (a) to secure
the shaft.
2. Mount the blade (b) on the bushing (a), making sure that the projection on the
bushing fits in the blade's fitting hole.
3. Fit the washer (c) and cup (d) against the blade, and finish by fitting the lock ring (e)
and nut (f). Make sure the washer is facing the proper direction (flat side against
blade).
4. Remove the allenwrench before use.
Always ensure blade is secure. If in doubt, contact your nearest dealer.
Using the blade
1. Keep blade in dense grass or weeds when stopping engine until rotation has
ceased.
2. Always hold machine securely in both hands.
3. Do not use if screen is incorrectly fitted and in poor condition.
4. Always stop engine before removing any materials stuck in blade.
5. Never attempt to touch or stop blade while it is rotating.
6. A rotating blade can cause injury, as it will continue to rotate after the engine is
stopped or gas regulator activated. Always maintain control over the machine until
blade stops completely.
7. Always ensure blade is correctly fitted before use.
8. Always use a sharp blade. Replace damaged or worn blades.
9. Use original spare parts only.
10. Use blade only for weeds, grass and the like.
20