SNOWJOE AUTOJOE AJV1000 Manuel D'utilisation page 6

3. Press the on/off button to turn on the vacuum. Keep the
nozzle approximately 0.4 inch (1 cm) over the material to
be vacuumed (Fig. 2).
Fig. 2
On/Off button
4. After use, turn off the vacuum by pressing the on/off
button (Fig. 2). Replace the vacuum cap before storing.
Empty the Dust Tank
It's recommended to empty the dust tank after use.
1. Remove the dust tank by twisting it clockwise, and pull it
out from the vacuum (Fig. 3).
NOTE: Point the vacuum nozzle toward the ground to
avoid dust spilling out when disconnecting the dust tank
from the vacuum.
Fig. 3
2. Remove the HEPA filter from the dust tank (Fig. 4).
1 Twist clockwise
Dust tank
2
Pull out
Fig. 4
3. Discard the dust and debris from the dust tank in
accordance with local laws and regulations.
4. After emptying, reinsert the HEPA filter into the dust tank,
and reattach the dust tank to the vacuum. Push in and
turn the dust tank counterclockwise until it locks in place
(Fig. 5)
Fig. 5
2
Twist
counterclockwise
HEPA filter
Use the 2-in-1 Nozzle +
Brush attachment
The included 2-in-1 nozzle + brush attachment is suitable for
cleaning small areas and collecting fine dust. To use the nozzle
+ brush attachment, follow the instructions below.
1. Turn off the vacuum.
2. Insert the 2- in -1 nozzle + brush attachment into the
vacuum nozzle and press firmly to attach (Fig. 6).
6
HEPA filter
Dust tank
1 Insert in
Dust tank