Panasonic EY46A2X Instructions D'utilisation page 12

WARNING
• It should never be necessary to
force the tool. The weight of the tool
applies adequate pressure. Forcing
and excessive pressure could cause
dangerous grinding disc breakage.
• ALWAYS replace grinding disc if tool
is dropped while grinding.
• NEVER bang or hit grinding disc.
• Avoid bouncing and snagging the
grinding disc, especially when
working corners, sharp edges etc.
This can cause loss of control and
kickback.
CAUTION
After operation, always switch off the
tool and wait until the wheel has come to
a complete stop before putting the tool
down.
01̲Eng̲EY46A2(EU).indd 12
Visual inspection and workout
test on disc
1. Always make sure that the disc has no
cracks before use.
2. Always give workout test on the blade
as follows.
3. Always make sure the disc is firmly
fixed.
Brand new disc
Before use on
current disc
Grinding operation
B
ALWAYS hold the tool firmly with one
hand on grip and the other on the
support handle. Turn on the tool and
then apply the wheel or disc to the
workpiece.
In general, keep the edge of the wheel
or grinding disc at an angle of about
15º-30º to the workpiece surface.
When using a new grinding disc, do
not work the grinder in the B direction
or it will cut into the workpiece. Once
the edge of the grinding disc has
been rounded off by use, the grinding
disc may be worked in both A and B
direction.
- 12 -
Work out time
more than 3 min.
more than 1 min.
° °
15 ~30
A
2014/07/02 12:01:22