Medisana 61148 Mode D'emploi page 19

3.2
Operation
4 Miscellaneous
4.1
Cleaning and
maintenance
3 Operating / 4 Miscellaneous
The heat pad features an electronic temperature control that regulates the
temperature according to the chosen setting.
Only use the heat pad in the cover supplied with it.
Place the heating pad around your neck with the opening at the front and close
the fastener.
Plug the unit into the mains outlet and move the slider control from position 0
to position 1. The power LED will light up in green. After a few minutes you
will be able to feel the pad getting noticeably warmer. If you require a higher
temperature setting, move the switch to the next positions, 2, 3, or to the
maximum heat setting, position 4. If the pad gets too hot for you, move the
slider back to position 3, 2 or 1.
After a short while the heating pad cools down noticeably.
To switch the unit off, move the switch back to position 0. The green power
LED will go out, indicating that the unit is switched off. Unplug the unit from
the mains outlet.
Move the selector switch to position 1 or 2 before falling asleep or any
continuous use. The heat pad will switch off automatically after approx. 90
minutes of continuous use. To switch it back on again, move the slider control
to position 0 and then back to the desired heat setting.
Unplug the unit from the mains outlet once you have finished using it.
Heat pad
• Before cleaning the pad, unplug it from the mains outlet and let it cool down
for at least ten minutes.
• The heating pad is equipped with a detachable cable. Disconnect the plug
and remove the cable from the heating pad.
• You may wash the heating pad gently by hand. The best way to do this is to
put the heating pad in a bath with lukewarm water and some mild
detergent and then gently squeeze it out.
• Rinse the heating pad several times to remove all the detergent.
• Store the unit in a clean and dry place, laid out flat with nothing covering or
resting on top of it.
• Only use the appliance once it is completely dry.
Heat pad cover
• Remove the heat pad from its cover.
• Dry clean the removable cover or as detailed in the instructions on the label.
GB
15