Renkforce 1275881 Notice D'emploi page 27

• Do not pull the plug-in mains adapter from the mains socket by pulling the cable.
• Protect the cables of the plug-in mains adapter from sharp edges, do not step on them.
• If the mains adapter is damaged, do not touch it. Danger to life from electric shock!
First deactivate all sides of the mains socket to which the plug-in mains adapter is connected
(e.g. switch off the respective fuse or turn out the fuse. Then deactivate the associated FI
protection switch).
Then unplug the mains adapter from the mains socket. Replace the damaged plug-in mains
adapter with a new one of the same build.
c) Indoor unit
• The indoor unit is only suitable for dry, closed rooms. Do not expose it to direct sunlight, heat,
cold, dust, dirt dampness or wetness; otherwise, it will be damaged.
• Never cover the ventilation openings on the back.
• Do not push the display surface too hard. This will not only leave scratches, but the display may
also break and be permanently damaged. Loss of guarantee/warranty!
d) Outdoor unit
• The outdoor unit is suitable for indoor and outdoor use (IPX4). However, it must never be oper-
ated in or under water; it would be destroyed by this.
Install the outdoor unit in the outdoor area under an advancing roof (e.g. an awning).
• Ensure that the connection cables are not crushed, bent or damaged by sharp edges.
• Install the outdoor unit so that the integrated camera does not point right at bright light sources
(e.g. the sun or spotlights). This will not only cause an overmodulated and useless image, but
also may damage the image sensor it permanently exposed.
• Before installation of the outdoor unit, observe any applicable provisions for whether operation
of the camera or its alignment with a specific area of the environment is permitted.
27