Publicité
Les langues disponibles
Les langues disponibles
TECHNICAL DATA
Working voltage: 120V
Nominal capacity of the tank: 4.5 Liters – 1.25 U.S. Gallon
Boiler power: 1 heating element 1200W
Power consumption: 16.7 amps (6000IS/120V), 10 amps (6000CJ, 6000CD)
Service pressure: 3.5 Bar/4 Bar
Maximum pressure: 4.5 Bar
HOW TO ASSEMBLE AND USE
1.
Remove the steam station from its packing and make sure all packing has
been removed (including the protective bags). Put the station on a flat and
solid surface.
2.
Your boiler is supplied with a safety cap on the blow-down valve (left side of
tank), as well as a plastic hose and fitting to secure the hose. Please remove
the safety cap and install the hose and fitting. This will allow you to follow the
proper cleaning procedure (ref. to flush the boiler tank). If there is a problem
with the blow-down valve (leaking) you can use the safety cap to prevent
water from leaking until you have the valve replaced.
3.
A) 6000IS/2100IR: It is recommended to put the iron on the iron pad, (sup-
plied) as the pad will withstand the temperature of the iron. B) 6000CJ:
Screw the nozzle into the steam fitting and plug in the 4-pin receptacle for
the electronic foot pedal. C) 6000CD: Connect the steam gun or steam brush
the same way using the quick disconnect for the steam hose.
4.
Insert the two-piece wand (mod. 6000IS) or one-piece wand (mod. 6000CD)
into the flange on top of the boiler, tighten with the side screw and attach
the spring on the hose (mod. 6000IS) to the coil end of the wand. Note: mod.
6000CJ is not supplied with a wand.
5.
Before beginning any operation, make sure that the exhaust valve (9) is
closed and the drain hose is installed (ref. step #2).
6.
Unscrew the safety cap (5). Fill the boiler with water to the maximum as
marked on the water level stick. Use the funnel supplied, making sure you do
not overfill the tank.
7.
Insert the plug into the electrical outlet; switch on the boiler (2) and steam
buttons (1). When the two button lights come on, the steam device and boiler
are working.
8.
For the 6000IS iron system, turn the iron plate's temperature regulating knob
(12) to the desired temperature.
05
Publicité
