GRE PP051 Manuel D'instructions page 6

This manual contains basic information on the safety measures to be adopted during
installation and start- up. The fitter and the user must therefore read the instructions
before installation and start-up.
GENERAL SAFETY REGULATIONS
• The machines indicated in this Manual are especially designed for the pre-filtering
and recirculation of water in swimming pools
• Install them in line with the specific instructions for each installation
• All modifications to the pump require prior authorisation from the manufacturer.
Original spare parts and accessories authorised by the manufacturer ensure greater
safety. The pump manufacturer is exempt from all liability regarding any damage
caused by unauthorised spare parts or accessories.
• When working on each machine or on the units linked to them, disconnect the unit
from the power supply and the startup devices, as the electrical parts of the pump
are live during operation.
• All assembly and maintenance work must be carried out by qualified and authori-
sed personnel who have carefully read the installation and service instructions.
• To guarantee safety when operating the machine, you must comply with that set
out in the installation and service instructions.
• In the event of defective operation or faults, contact your supplier or nearest repre-
sentative.
• If the power supply cable is damaged, the manufacturer, its after-sales service of
qualified technicians, should replace it in order to avoid hazards.
• The device should be connected to electricity outlet with earth connection, protected
by a Residual Current circuit breaker that does not exceed 30 mA.
• Make sure that water is unable to enter the motor or the live electrical parts.
• Avoid contact at all times - even accidentally - with moving machine parts while the
machine is running and/or before it comes to a complete standstill
• Wait for the machine to come to a halt before handling it.
• Before any electrical or mechanical maintenance operation, disconnect the unit
from the power supply and block the start-up devices.
• To reduce risk of injury, children should not use this product.
• Do not bury the electric cable. Lay the cable so it cannot be damaged by machi-
nery, like mowing machines, etc.
• Do not start the pump before it is correctly connected to the swimming pool.
• To reduce risk of electric shock, change the electric cable immediately when dama-
ged.
• To reduce risks of electric shock, do not use extension cables to connect the p mp to a
power supply. Connect it to a correctly installed electricity outlet.
• Do not use the pump without water!
INSTALLATION
• Only authorised and qualified personnel should install the pump and its cabling,
respecting the current legislation.
• The pump should be installed horizontally, screwing it to the support, to avoid vibra-
tion and unwanted noise.
• The pump should be installed far from any corrosive or flammable products.
• The pump should have sufficient drainage to avoid risk of flooding and should be
protected from excessive humidity.