Whirlpool WMC10009 Guide D'utilisation Et D'entretien page 7

NOTE: The display language may be set to French, and the
weight entry mode may be set to metric. See "Language" and
"Weight Entry Mode" sections.
When the microwave oven is in use, the display will show cook
time remaining. When the microwave oven is not in use, the
display will show the time of day (if the clock is set) or Timer
countdown (if the Timer is set).
The START control begins any function. If cooking is interrupted
by opening the door, touching START will resume the cycle.
NOTE: To avoid unintentional operation of the microwave oven,
a cooking function cannot be started if the microwave oven door
has been closed for about 5 minutes. The word "door" will
appear in the display until the door is opened and closed.
Add 30 Seconds
The ADD 30 SEC control (START pad) automatically starts the
microwave oven at 100% power for 30 seconds, and adds
30 seconds of cook time, up to 10 minutes, with each additional
touch of the control.
Time may be added to any manual cooking cycle in 30-second
increments, up to 10 minutes, at the current power level, by
touching ADD 30 SEC during cooking.
NOTE: To avoid unintentional operation of the microwave oven,
a cooking function cannot be started if the microwave oven door
has been closed for about 5 minutes. The word "door" will
appear in the display until the door is opened and closed.
Pause/Cancel
The PAUSE/CANCEL control clears any incorrect command, and
pauses and/or cancels any program during cooking. The first
touch pauses a cooking cycle, and the second touch cancels the
cycle. It will not erase the time of day.
The microwave oven will also pause when the door is opened.
Close the door and touch START to resume the cycle.
The PAUSE/CANCEL control is also used to lock and unlock the
control panel. See "Control Lock."
This is a 12- or 24-hour clock.
To Set:
The microwave oven must be off.
1. Touch CLOCK once for 12-hour setting, or twice for 24-hour
setting.
2. Touch number pads to enter correct time of day.
3. Touch CLOCK.
NOTE: The Timer does not start or stop the microwave oven.
Cook functions may be used while the Timer is counting down.
When the cook function is active in the display, touch TIMER to
see the Timer count down.
To Set:
1. Touch TIMER.
2. Touch number pads to enter desired time.
3. Touch START.
When the set time ends, the end-of-Timer tone will sound.
Start
Clock
Timer
4. While the Timer countdown is active in the display, touch
PAUSE/CANCEL to cancel the Timer.
If a cook function countdown is active in the display, touch
TIMER to show the Timer countdown, then touch
PAUSE/CANCEL to cancel the Timer. Touching
PAUSE/CANCEL while a cook function countdown is active in
the display will cancel the cook function, not the Timer.
Tones are audible signals that can be turned off.
To Turn Off/On Reminder Tones: With the door open, touch and
hold number pad "6" for 5 seconds, until a tone sounds. Repeat
to turn tones back on.
To Turn Off/On All Tones: With the door open, touch and hold
number pad "5" for 5 seconds. Repeat to turn tones back on (A
tone will sound).
These tones indicate the following:
One tone
Valid entry
Control lock activated or deactivated
Two tones
End of stage in multistage cooking
Reminder
During Defrost cycle, reminder to check, turn, rearrange, or
separate food
Three tones
End of Timer countdown
Four tones
End of cycle
Control Lock
The Control Lock disables the control panel pads to avoid
unintended use of the microwave oven.
To Lock/Unlock Control: The microwave oven must be off.
Touch and hold PAUSE/CANCEL for 5 seconds until the tone
sounds and the LOCK icon appears in the display. Repeat to
unlock and clear the display.
If any cook function control is touched while the Control Lock is
active, a tone will sound.
Language
The default display language is English, but may be set to
French. Two display messages are affected: "End" (English) or
"Fin" (French), and "door" (English) or "PrtE" ("porte" - French).
To Set Language to French: With the microwave oven door
open, touch and hold POWER LEVEL for about 5 seconds, until a
tone sounds. To change back to English, disconnect power, then
reconnect power to microwave oven.
Weight Entry Mode
The default weight entry mode for Weight Defrost is imperial
(pounds), but may be set to metric (grams). This setting does not
affect any other program besides Weight Defrost. See "Weight
Defrost/Timed Defrost" section.
To Set Weight Entry to Metric: With the microwave oven door
open, touch and hold number pad 0 for about 5 seconds, until a
tone sounds.
Tones
7