Télécharger Imprimer la page

Candy CDP 1LS64W Mode D'emploi page 14

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 34
PROGRAMME SELECTION
AND SPECIAL FUNCTIONS
(Use in conjunction with programme guide)
Programme settings
Open the door and place the dirty dishes
inside the appliance.
Press the "ON/OFF" button for about 2
seconds.
All the programme indicator lights will
flash.
Choose a programme by pressing the
"PROGRAMME SELECTION" button.
The selected program indicator light will
flash.
If you wish to select an option, press the
corresponding button (the indicator light
will turn on).
The option buttons can be selected or
deselected WITHIN one minute of the
programme commencing.
Press the "START" button (the selected
programme indicator light will stop
flashing and remain on.
When the door is shut, after an audible
signal has sounded, the programme will
start automatically.
WITHIN one minute of the programme
commencing, another programme
can be selected, simply by pressing
the
"PROGRAMME
button.
Programme interruption
Opening the door when a programme is
running is not recommended especially
during the main wash and final hot rinse
phases. However, if the door is opened
while a programme is running (for example,
to add dishes) the machine stops
automatically.
Close the door, without pressing any
buttons. The cycle will start from where it
left off.
SELECTION"
14
IMPORTANT
A running program can be interrupted
without
opening
pressing the "ON/OFF" button. In
this case, simply press the "ON/OFF"
button again to restart the cycle from
where it left off.
WARNING!
If you open the door during the
drying cycle, an audible audio signal
advises you that the drying cycle has
not yet finished.
Changing a running programme
Proceed as follows to change or cancel a
running program:
Hold the "RESET" button down for at
least 3 seconds.
Some audible signals will sound and the
programme indicator lights will turn on
and off individually and sequentially.
The running programme will be cancelled
and all the programme indicator lights will
flash.
At this point a new programme can be set.
WARNING!
Before starting a new programme,
you should check that there is still
detergent in the dispenser.
If necessary, top up the dispenser.
the
door
by

Publicité

loading