Publicité
Les langues disponibles
Les langues disponibles
UV Lamp replacement
1.
Open the UV lamp cover with a screwdriver.
2.
Grasp the wire connector and gently unplug it, remove the UV bulb from unit.
3.
Install the new UV lamp and reattach the cover.
Note: Do not watch the operating UV lamp directly. Do not touch the UV lamp with
your fingers. This could have the consequence of reducing its lifespan.
Product cleaning
•
Make sure to unplug the appliance before cleaning it.
•
Do not put the appliance into the water or use water directly to wash it.
•
Do not use any corrosive or flammable detergent to clean the appliance, as this
may cause damage.
•
You can use a soft cloth with daily cleanser to clean the appliance, and make
sure the appliance is dry after cleaning.
•
Regularly clean the inside and surface, to prevent dust accumulation.
•
Regularly clean the air inlet and air outlet.
•
Regularly clean the dust sensor with a cotton swab to protect its sensitivity.
When long time without use
•
If the appliance is not used for a long time, please pack it well and store it for
protection.
•
When use after long storage period, please proceed as below
1.
Clean the pre-filter and make sure it is dry.
2.
Use soft cloth to clean the HEPA and Activated Carbon filter, and make
sure it is dry.
3.
Use a soft cloth to clean the air inlet and air outlet.
Caution
Proper use and regular maintenance can ensure the proper functioning of
the appliance and extend its service life. Only qualified professionals should
disassemble the appliance, as this may cause electric shock or damage.
MAINTENANCE CAUTION
Screws
Connector
21
Publicité
