Publicité
Les langues disponibles
Les langues disponibles
Safety Information
Electrical Requirements
Important:
►
Observe all governing codes and ordinances.
►
It is the customer's responsibility to be aware of these below:
►
To contact a qualified electrical installer.
►
To assure that the electrical installation is adequate and in conformance with National Electrical Code, ANSI/NFPA 70 latest
edition* or CSA standards C22.1-94, Canadian Electrical Code, Part 1 and C22.2 No.0-M91 - latest edition** and all local codes
and ordinances.
►
If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path
is adequate.
►
Do not ground to a gas pipe.
►
Check with a qualified electrician if you are not sure the range hood is properly grounded.
►
Do not have a fuse in the neutral or ground circuit.
►
This appliance requires a 120V 60Hz electrical supply and connected to an individual properly grounded branch circuit protected
by a 15 or 20 ampere circuit breaker or time delay fuse. Wiring must be 2 wire with ground. Please also refer to Electrical Diagram
on product.
►
Instructions for bonding the appliance to ground:
The grounding-type attachment plug provided with this appliance shall be connected to a grounding-type receptacle installed in
accordance with CSA C22.1, Canadian Electrical Code, Part I. In the event of an electrical short circuit, bonding to ground reduces
the risk of electric shock.
WARNING: Improper bonding to ground can result in a risk of electric shock.
Consult a qualified electrician if the grounding instructions are not completely understood, or if doubt exists as to whether the
appliance is properly bonded to ground. Do not use an extension cord. If the poewr supply cord is too short, have a qualified
electrician install an outlet near the appliance.
►
A cable locking connector (not supplied) might also be required by local codes. Check with local requirements, purchase and
install appropriate connector if necessary.
* National Fire Protection Association Batterymarch Park, Quincy, Massachusetts 02269
** CSA International 8501 East Pleasant Valley Road, Cleveland, Ohio 44131-5575
Federal Communication Commission Interface Statement
►
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
►
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following
measures:
►
Reorient or relocate the receiving antenna.
►
Increase the separation between the equipment and receiver.
►
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
►
Consult the dealer or an experienced radio/TV technician for help.
6
READ AND SAVE THESE INSTRUCTIONS
Siena Pro Use, Care, and Installation Guide
C O R E
S I E N A P R O
WA L L
Publicité
