HomeMatic IP HmIP-eTRV-E Notice D'installation Et D'emploi page 22

General system information
5 General system information
This device is part of the Homematic IP
Smart Home system and communica-
tes via the Homematic IP wireless pro-
tocol. All devices in the Homematic IP
system can be configured easily and
individually with a smartphone using
the Homematic IP app. Alternatively,
you have the option of operating
Homematic IP devices via the CCU3 or
in conjunction with many partner so-
lutions. The available functions provi-
ded by the system in combination with
other components are described in the
Homematic IP User Guide. All current
technical documents and updates can
be found at www.homematic-ip.com.
6 Start-up
6.1 Pairing
Please read this entire section
before starting the pairing proce-
dure.
First set up your Homematic IP
access point using the
Homematic IP app so that you can
use other Homematic IP devices
in the system. For further informa-
tion, please refer to the Access
Point operating manual.
For more information on pairing
and setting up the wall thermostat
using a CCU3, please refer to the
WebUI manual on our homepage
at www.homematic-ip.com.
To integrate the radiator thermostat
into your system and enable it to com-
municate with other Homematic IP de-
vices, you must add the device to your
Homematic IP Access Point first.
Proceed as follows to add the device:
• Open the Homematic IP app on
your smartphone.
• Select "Pair device".
• Open the battery compartment (C)
by sliding the battery compartment
cover (C) downwards.
Figure 2
• Remove the insulation strip from
the battery compartment of the
radiator thermostat. The pairing
mode is active for 3 minutes.
Once the insulation strip has been
removed, the motor retracts to
make subsequent installation
easier. Meanwhile, "
activity symbol ( ) are displayed.
You can manually start the pairing
mode for another 3 minutes by
briefly pressing the system button
(D). If the display is off, simply
press the system button briefly to
activate the pairing mode. When "
" is shown in the display and
MANU
BOOST
you press the system button
C
again, the adjustment run starts.
This behaviour can be ignored at
this time.
MANU
BOOST
" and the
C
22