Publicité
L920-B3
Bollard Stake Light
Parts
LED Unit with B3 canopy
Pipe stake (PS)
Set screws x 3
Waterproof wire nuts x 2
Mounting screws — Not included
Allen key — Included
1) Drill a hole into the side of the pipe
stake for wire to come out.
2) Connect fixture leads using
supplied waterproof wire nuts.
Power to the remote driver must
be off while wiring LED fixtures to
drivers.
3) Push pipe stake into soil leaving
enough pipe on the surface to
connect B3 canopy.
4) Attach B3 canopy to pipe stake,
securing with 3 set screws.
www.mplighting.com t 1.877.708.1184 f 604.708.1185
line
connect
neutral
to mains
ground
All technical information in this document is subject to change. Copyright © MP Lighting.
LED unit
B3 Canopy
Set screw
Waterproof
wire nut
Pipe stake
Soil
positive
(red)
LED driver
negative
(blue)
connect
to fixture
08-2023
Publicité
