Lubrication - Genesis GBDS450 Manuel D'utilisation

WARNING:
ends of a work piece on the idler drums. It
could cause the work piece to fly up and result
in personal injury.
Always sanding the outside curve on the left hand side
of the sanding disc, as shown in FIG 20
WARNING:
the right side of the sanding disc could cause
the work piece to fly up and result in personal
injury.
MAINTENANCE
CLEANING
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from
various types of commercial solvents and may be damaged by their use. Use clean cloths to remove
dirt, dust, oil, grease, etc.
WARNING:
based products, penetrating oils, etc., come in contact with plastic parts.
Chemicals can damage, weaken or destroy plastic which may result in serious
personal injury.
Electric tools used on fiberglass material, wallboard, spackling compounds, or plaster are subject to
accelerated wear and possible premature failure because the fiberglass chips and groundings are
highly abrasive to bearings, brushes, commutators, etc. Consequently, we do not recommend using
this tool for extended work on these types of materials. However, if you do work with any of these
materials, it is extremely important to clean the tool using compressed air.

LUBRICATION

This tool is permanently lubricated at the factory and requires no additional lubrication.
TWO-YEAR LIMITED WARRANTY
This product is warranted free from defects in material and workmanship for 2 years after date
of purchase. This limited warranty does not cover normal wear and tear or damage from neglect
or accident. The original purchaser is covered by this warranty and it is not transferable. Prior to
returning your tool to store location of purchase, please call our Toll-Free Help Line for possible
solutions. THIS PRODUCT IS NOT WARRANTED IF USED FOR INDUSTRIAL OR COMMERCIAL
PURPOSES. ACCESSORIES INCLUDED ARE NOT COVERED BY THE 2 YEAR WARRANTY.
TOLL-FREE HELP LINE
For questions about this or any other GENESIS Product,
888-552-8665
Please call Toll-Free:
www.richpowerinc.com
Or visit our web site:
Never attempt to sand the
Sanding the work piece on
Do not at any time let brake fluids, gasoline, petroleum-
. (Mon-Fri, 9:00 am to 4:30 pm EST.)
FIG 20
13