Genesis GBDS450 Manuel D'utilisation page 10

WARNING:
spring loaded. Be careful when pushing the
tension lever back into place to avoid personal
injury.
Installing Table Assembly
To Install the Table Assembly for Use with
Sanding Disc (FIG 7,8, 9)
1. Unplug the sander from the power source.
2. Insert the position pin on table support into the upper hole
on the machine. See FIG 7.
3. Insert table lock knob (1) through a flat washer and the
table support slot and into the threaded hole of base as
shown on FIG 7. Turn and tighten the table lock knob.
4. Loosen the three hex head nuts at bottom of table support
(FIG 9) and adjust table to make sure the table edge is
no more than 1/16" (1-2mm) from the sanding surface.
Tighten the three hex head nuts. Re-tighten the lock knob.
WARNING:
piece or your finger between the table and
sanding disc, the table edge must be no more
than 1/16" (1-2mm) from the sanding surface.
To Install the Table Assembly for Use with
Sanding Belt (FIG 9, 10, 11)
1. Unplug the sander from the power source.
2. Remove the work support if it is on.
3. Place the belt bed in the vertical sanding position. Refer to
"Positioning the Belt Bed".
4. Insert the position pin on table support into the position
hole on the belt bed as shown on FIG 10.
5. Insert table lock knob through a flat washer and the table
support slot and into the threaded hole as shown on FIG
10. Turn and tighten the table lock knob (1).
6. Loosen the three hex head nuts at bottom of table support
and adjust table to make sure the table edge is no more
than 1/16" (1-2mm) from the sanding surface. Re-tighten
the lock knob.
7. Adjust the protection plate (2) under the table to cover the
exposed sanding belt for extra protection.
Installing Work Support (FIG 12)
1. Unplug the sander from the power source.
2. Place the work support (1) over the hole in the side of the
tool housing as shown in FIG 12.
3. Using a wrench provided, fasten the work support in place
with the washer and hex head screw (2).
Belt/Disc Sander
Operator's Manual
The belt tension lever is
To avoid trapping the work
FIG 8
FIG 9
1
GBDS450
FIG 7
1
FIG 10
2
FIG 11