Genesis GBDS450 Manuel D'utilisation page 11

Mounting Belt/Disc Sander
If during operation of the Belt/Disc Sander, there is any
tendency for the sander to slide or "walk" or to tip over,
then the sander must be secured to a work bench or other
supporting surface using fasteners (not supplied) through
the two holes in the sander base.
ADJUSTMENTS
WARNING:
is switched off and unplugged from the power
source before adjusting, adding accessories,
or checking a function on the tool.
Adjusting the Belt Tracking (FIG 13)
1. Plug the sander into the power source.
2. Turn switch 'ON' and immediately 'OFF', noting if the belt
tends to slide off the idler drum or drive drum. If it did not
tend to slide off, it is TRACKING properly.
3. If the sanding belt moves toward the disc, turn the
tracking knob (3) clockwise 1/4 turn.
4. If the sanding belt moves away from the disc, turn the
tracking knob (3) counterclockwise 1/4 turn.
5. Turn switch 'ON and immediately 'OFF' noting belt
movement. Re-adjust tracking knob if necessary.
Positioning Belt Bed (FIG 14)
The belt bed lock screw (4) locks the belt bed in a horizontal
or vertical position.
To adjust the belt bed position
1. Unplug the sander from the power source.
2. Loosen the lock screw (4) using Allen wrench provided.
3. Position belt bed and re-tighten the lock screw (4).
OPERATION
WARNING:
is switched off and unplugged from the power
source before adjusting, adding accessories,
or checking a function on the tool.
ON/OFF Switch (FIG 15)
1. To turn the sander ON, move the switch (1) to
the"ON" position.
2. To turn the sander OFF, move the switch to the
"OFF" position.
3. To lock the switch in the OFF position, remove
the safety key (2) from the switch. Store the key in a
safe place.
Always be sure that the tool
Always be sure that the tool
1
2
3
FIG 13
4
FIG 15
1
FIG 12
FIG 14
2
11