Publicité
Les langues disponibles
Les langues disponibles
3-C Install With Base
Rear-Facing With
Vehicle Seat Belt
30
All manuals and user guides at all-guides.com
1. Store LATCH
Straps
Hook the LATCH
hooks into the holes
on side of base as
shown. Remove the
slack.
2. Place Base in
Back Seat of the
Vehicle
Place the base flat
on the vehicle seat.
Push it back until
the front of the base
touches the vehicle
seat back.
3. Check the Rear
Facing Level
Line
The red level line on
the side of the seat
MUST BE LEVEL
with the ground.
If needed, rolled
towels may be placed
under the base, at the
vehicle seat crease,
until the level line is
level with the ground.
Review your vehicle's owner manual for vehicle seat
belt use
4. Route the Vehicle
Seat Belt
Thread vehicle seat
belt through the
rear-facing belt path
(marked with a blue
label) and buckle it.
The seat belt should
lay as flat as possible
and not be twisted.
31
Publicité
