Publicité
Les langues disponibles
Les langues disponibles
5. Cooling filter cleaning:
- Disconnect the equipment from the power outlet.
- Remove the filter by pulling it up. (fig.4)
- Clean the filter with the help of a mild detergent and a soft brush.
- Place the filter in the equipment when it is completely dry.
6. Water tank cleaning:
- Disconnect the equipment from the power outlet.
- Remove the tank by pulling it out. (fig.5)
- Clean the tank with the help of a mild detergent and a soft brush.
- Place the tank in the equipment.
8. TROUBLESHOOTING
PROBLEM
Device does not
work.
There is no air flow.
Device isn't cooling.
Bad smell.
Increasing hot
sensation in the
room.
POSSIBLE CAUSE
There is no electrical current.
Damaged engine.
Blockage in the grid or filters.
Low water level.
Damaged water pump.
The filter is dirty.
There is too much humidity in the
environment.
The water or the filter is dirty.
There is no air renewal and the relative
humidity is getting too high.
SOLUTIONS
Check that the power cord is plugged
in.
Check the power supply.
Press ON/OFF.
Contact Technical Service.
Clean equipment.
Fill the water tank.
Contact Technical Service.
Clean equipment.
You can use the computer as a fan.
Change water or clean equipment.
Make sure that the room is well
ventilated and the equipment can
constantly receive fresh air.
12
Publicité
