Publicité
Les langues disponibles
Les langues disponibles
Installation (continuea)
O Installation Location
Do not install this unit on the rear tray of a car where the internal temperature can rise to high levels. Failure to
comply with these instructions may cause problems. Also avoid installing the unit in the following locations.
e In areas hit by direct sunlight, hot air from the heater, or any other high-temperature location.
e In an area where you cannot firmly secure the unit, or in high-vibration areas.
e In areas with high humidity or high dirt and dust levels.
Note:
Be sure to tighten the screws after setting. Be sure to set the screws on both the left and right sides.
Installation and the Mounting Angle
ae
|
Horizontal mounting
|
Mounting at 22.5°
CORRECT
WRONG
CORRECT
i
Normal
Inverted
Position
Position
Installation
Top side
of unit.
acm
ort
.-
-r
ao eT
V-H Screw Position
yes 45° sy O
y os 45° 25yO
Left side
Right side
EHI 45° e750
yes. 45° 2251. O
Left side
Right side
Position of screw
holes of mounting
bracket
14
CX-DP610EUC
Publicité
