Publicité
Les langues disponibles
Les langues disponibles
Installation
Q Precautions
If possible, this equipment should be professionally installed. In case of difficulty; please consult with your near-
est professional installer.
1. This unit operates only in a 12-volt OC negative ground system.
2. Before performing installation and wiring, remove the negative (—) terminal of the battery. (See Note Below.)
Note: Do not disconnect the negative battery terminal in vehicles with trip or navigational computers. All elec-
tronic memory settings previously registered will be lost. Take extra care to avoid short circuiting when installing
the unit.
3. Insulate all exposed wires to prevent short circuiting.
4. Secure all loose wires after installing the unit.
5. First, connect the extension cord (D (supplied) (See page 18) to the CD changer and then, connect
the RCA pin connectors and the extension cord 8p DIN connector to the CD/Cassette Receiver. Fi-
nally, connect the battery cord to a constant power supply.
. Please carefully read the operating and installation instructions of any equipment connected to this unit.
7. If the unit doesn't work after pressing other buttons, press the reset switch. If pressing the reset switch does-
n't restore regular operation, please consult your nearest professional installer.
>
Q Installation Hardware
Base Bracket
Hex. Nut (M5)
Mounting Bracket (L)
Mounting Bracket (R)
Double-Faced Adhesive Tape
CX-DP610EUC
© In
13
Publicité
